Skip to main content

Autoclaves are validated according to EN 13060 and EN 285 standards. After the studies to be carried out in your facility, the samples collected are analysed in our laboratories and all results are reported.

We will perform the following steps for the autoclave validation study;

  • Preparation of the validation protocol,
  • Performing the device probe verification,
  • Performing a vacuum test,
  • Performing repeated cycles for heat penetration (empty/full),
  • During these cycles, the results are recorded with a standardized number of independent data loggers,
  • Preparation of a validation report describing the whole process with the results.